Motion Raceworks Driver Side LS Mechanical Cable Drive Fuel Pump Bracket Corvette Spacing

Motion Raceworks’ goal is to bring viability to the market. This complete fuel system bracketry kit gives you everything you need to get going. This kit uses the HTD pulley that bolts to the back of the ATI Balancer to drive the system.

NOTE: If you have any questions on pulley combinations, compatibility, etc. please call us at (800) 878-9274.

Included in this kit are the following:

• Driver side block mounting bracket (non motorplate setup)
• Required Spacersand Hardware
• Adjustable Pulley/Shaft Mount
• Corvette Pulley Size (56 tooth)
• Correct Length Belt
• Waterman Cable Drive Adaptor for Front (Rear of Bracket not pictured)

Note: Main cable drive fuel pump mount for rear of car and cable still needs to be purchased: https://www.motionraceworks.com/products/waterman-chassis-mount-bracket-w-cap-for-tube-sizes-1-1-1-8-1-1-4-1-3-8-1-1-2-1-5-8

Optional:

• ATI pulley with HTD drive setup on rear (choose pulley spacing style, see below)
• Pump/Regulator/Filter Kit

Suggested ATI Components forCorvette Spacing

• Complete Balancer with HTD Hub: https://www.motionraceworks.com/collections/ati-performance-products/products/ati-corvette-super-damper-balancer-w-8mm-htd-28-tooth-pulley-complete-917304-ls1-2-3-6
• HTD Hub Only To Replace Current Hub: https://www.motionraceworks.com/products/ati-ls1-2-3-corvette-y-body-hub-w-htd-8mm-28tooth-hub-only-916033a

NOTE: This system will not allow you to run AC drives in conjunction.

Learn how to properly size / select a pulley combination for your mechanical fuel pump / mechanical oil pump.

Watch us install this kit used as a cable drive on Cleetus McFarland’s Leroy Stick Shift World Record Holding Corvette for more info and tips!